Warning: Last items in stock!
The 4mm pan head screws are for the board side.
The 4mm countersunk screws are suitable for hammond enclosures, milled gboxes or any other enclosure with a wall thickness of 1.8mm
The 7mm countersunk screws are suitable for enclosures with a thicker wall, up to 4mm just file to size.
The included nut is to be used with the spare case screw for those that appreciate symmetry :)
An adhesive cutting template is included. Simply trim to the red lines and affix. Applying some clear tape over the top of the template is advised.
The template also has dimensions for vamo buttons, however if using vamo buttons a little has to be filed off the bottom to make them fit without firing the board switches.
We're unsure about how different metals will react with each other when used for a common ground, whether there will be some sort of corrosion or oxide build up so it for this reason that we advise a ground wire is still used.
|10||10%||Up to £ 2.99|
|50||15%||Up to £ 22.43|
|100||20%||Up to £ 59.80|
No customer reviews for the moment.
At some point we'll be shipping these without a locking washer as stock...
A selection of M1.6 threaded fittings to mount a DNA250, 200 or 75 3...
R2 with some cosmetic and material changes. Notable changesCentre...
Some images shown have actuators in, they are for display purposes and...
22mm High temperature insulator Brass centre pin M10 x 0.75mm thread...
Black anodised aluminium Flat actuator 12mm 12.1mm cut out...